Enthuspec Elantra N Carbon Fiber Brake Duct Overlay
This is for those DIY Racers!
Carbon Fiber overlay brake duct that was developed for the Hyundai N Cup Car in Korea and TC Elantra race car.
Accepts a 2.5 to 2.75 brake duct piping
Sold as a Pair (1 left and 1 right)
***DIY Racers --READ Before Purchasing***
This is an overlay which means you lay this ON TOP over your OEM plastic bumper cover. In order to do this, you need to cut your bumper panel a hole large enough to allow this to fit. This takes some time and you need to make sure you do not trim too much or you will have trouble securing this. It uses the OEM Plastic as its mounting surface. Once you have it cut and able to insert this overlay, you then you need to secure it with bolts or long rivets. 1/8inch rivets or bolts are perfect for the job. Ideally 3-4 will be sufficient for securing this.
Keep in mind that is an OVERLAY, so the corners and fitment are not 100% the same size as the OEM plastic panel. Was never intended to be exact size but a bit undersized so it can be mounted just on the panel and not touching other parts of the bumper area.
We supplied some images in this listing.
THIS IS A RACING PART and ONLY a RACING Part so please don't ask was "fog light" might fit in there or why it is not show car quality. Its meant to direct air to a TUBE that will then get air to the brakes. You will need to come up with your own tube plumbing and mounting of the tube to your rotor area.
Note: These are built to order so expect at least a 2 - 3 week lead time.
English